Saturday, 21 November 2026

AlsoZone GaN Mono Amp - GaN tech, review, and measurements.

I suspect many of us in the audiophile community have heard of gallium nitride or GaN for short. Without going into the physics of it all (read up on it here, and also here), suffice it to say that GaN transistors, mostly consisting of a thin layer of AlGaN grown on GaN (pseudo-)substrate are the next big thing in solid state high-frequency technology. You'll hear terms like GaN FET or specifically HEMT (High-Electron-Mobility Transistors) internal architecture referring to this class of transistor. Specifically for Class D (typically PWM) amps, they benefit from faster switching than MOSFET which is the fastest mainstream silicon technology today.

How fast is GaN, you might ask? Well somewhere like 3-10x faster.

In practice, if we look at the switching speed of silicon Class D amplifiers, they typically run somewhere around 300-600kHz whereas GaN designs can run around 1-2MHz at similar if not better efficiency. Tangibly, it is this better efficiency which results in less energy used, less heat produced, less cooling needs, and smaller size that we can look forward to.

Here are a couple of illustrations showing some theoretical gains that GaN can make:

Illustrative Efficiency vs. Power graph, typical amplifier classes.
Theoretical 50% ceiling for transformer/push-pull Class A; in practice
significantly lower.

Faster and more predictable GaN switching allows shrinkage of
"dead time" compared to silicon (in nanoseconds). This reduces a crossover-like,
odd-order, higher harmonic distortion. Feedback error correction
can also be reduced.

That's theoretically all well and good! But as audiophiles, we'll no doubt be asking - What about sound quality? As usual, there will be good GaN-based amps and poor ones, it's a more difficult question to answer and will demand our own efforts, listening tests, informed by personal preferences. My perspective is that we can answer questions of high-fidelity through measurements at least - which might be most of what one needs, depending on philosophical leaning.

For this post, let's look what I think is currently the least expensive GaN amp widely available for audio enthusiasts - the AlsoZone GaN Mono (currently US$110 for just the amp, and US$140 with GaN 48V/5A switching power supply, Canada link + power supply, AliExpress). Don't forget to include the price of a power supply because it's not included in the base unit.

I obtained the device through the usual consumer channels; this review is not sponsored.

Saturday, 14 November 2026

MUSINGS: New Dimensions in Hi-Fi? "Trust your ears" vs. "Trust your whole sensory experience". Wisdom to the young. And the rise of Chi-Fi modding?! ๐Ÿ˜


The other day I saw a recent Stereophile "As We See It" article by Ola Bjรถrling (one of the magazine's new writers?) - "New Dimensions in Hi-Fi".

One might imagine that an article of that title in an audio magazine with discussion in the text of 3D objects intruding into 2D space (referencing Flatland) and the evolution of audio hardware might at least hint at progress like multichannel audio? Especially now in late 2026 with thousands of albums available in 5.1, 7.1, and Atmos (see Hello Atmos site for available content including streaming titles on Apple Music and Tidal).
[As discussed previously (here, and here), if one truly desires an elevated reproduction of audio in a real-sounding space, one must explore spatial immersion beyond typical 2-channel stereo which has its limits.]
Alas no, this is Stereophile and they're stuck still on the question of how to entice young people to spend money in the "hi-end" 2-channel Industry.

Sadly, there's nothing new being expressed in this commentary and there are no helpful new ideas being offered that we haven't already thought about for years. If that was all, then it would be easy to just move on. However, there are clearly other issues with the article and the mindset of writers like this in the audiophile magazines worth dissecting a little deeper, hopefully in time correcting.

Saturday, 7 November 2026

Loudspeaker Brand Sound Signatures: Stereophile-sourced Synthesis.

As per last week's explorations using AI-assisted research into Stereophile's measurements, we can see that there's a lot of data out there gathered over the decades. While we can look at measurements individually, I think it's more fun to combine the data together to find trends that might be hard to spot.

I suggested that one interesting area of exploration is to examine audiophile loudspeaker brands and see if we can pick out a "house sound" or "brand signature" to the products from the companies. By doing this, not only can we see the tonal tendencies of brands, but perhaps even more interestingly, we can see just how varied the sonic signature can be between different models of the same brand. I suspect that technically-oriented companies that rely on measurements would probably create products with tighter sonic character that hugs closer to their ideal target such as a flatter frequency response or better off-axis performance.

Since the AI already pulled the data, let's have it go a bit deeper and show us what the signatures look like among multiple companies. I'll present the graphs alphabetically by brand name.

Brands discussed/analyzed: Aerial Acoustics, Audio Note (UK), B&W, Boston Acoustics, DALI, DeVore, Dynaudio, EgglestonWorks, ELAC, Epos, Estelon, Focal, Hales, Harbeth, JBL, Joseph Audio, KEF, KLH, Klipsch, Linn, Magico, Marten, Mission, MoFi, Monitor Audio, NHT, Paradigm, Polk Audio, ProAc, PSB, Q Acoustics, Revel, Rockport, Sonus Faber, Spendor, TAD, Tannoy, Tekton, Thiel, Totem, Triangle, Vandersteen, Vienna Acoustics, Vivid Audio, Wharfedale, Wilson, Zu, Apogee, Avantgarde, Magnepan, MartinLogan, MBL, McIntosh, QUAD, B&O, Shahinian.

Sunday, 1 November 2026

Stereophile's loudspeaker measurements across time. Have loudspeakers improved? And the Wilson Audio, Sonus Faber, KEF "house sound".

Over the years, I've talked about using AI technology to help us understand the audiophile world (just a tiny piece among many, many other things to understand of course ๐Ÿ˜). In early 2023 I discussed using LLMs like ChatGPT to generate content including the ease of making "subjective" text such as for product reviews. By 2024, we discussed the multi-modality of AI technologies; the ability to "imagine" not just words but also across generated visual and audio content. But then there are also silly uses like trying to sell snake oil.

While I think we have reason to be concerned about whether the financial model is going to work out with the massive AI infrastructure buildout currently under way, and the survival of many AI-related companies, IMO the technology and gains we've made with machines capable of thought is real even if we do have to ride out another Y2K-like Dot-Com Internet Bubble. It'll be painful (always is) for investors, but corrections are necessary.

Over the last year, we are now clearly in the midst of an "agentic AI" expansion where the public can now access virtual assistants to help us out with tasks beyond just chatbot Q&A interactions (OpenClaw being one that made headlines in November 2025, at that time called Clawdbot). Agents, like secretaries and assistants can do work for us behind the scenes like research, creation of reports, even do stuff like sending off E-mails or finding good deals on stuff to buy! We know that already more than half of Internet traffic these days is non-human agentic bots.

It's a brave new world that requires TRUST of course. For now at least, even though I'm OK with my AI agents seeing my work schedule and some personal E-mails, I certainly would not want to be the guinea pig giving it access to autonomously send off serious work without review or my credit card and bank numbers. ๐Ÿค”

So, what does this have to do with audiophilia? Well, already it has been nice to get my agents to gather research data for blog articles. For example, a few months ago in April, I used my agent to gather data on inflation and examine the price of Stereophile Recommended Components. In September, an agent crawled across the Steve Hoffman Forums exploring what audiophiles are talking about these days. And now as we approach the end of 2026, we can access even more full-featured agents at our disposal that are capable of creating full briefings and analyses in ways that would take hours if not spread out over days to complete.

As I've noted over the years, I like Stereophile and the measurement data they've published across the decades on "High-End" products. It gives us a look into this "class" of devices that most hobbyists would not be able to test out for ourselves. In particular, large, expensive, loudspeakers are not the kinds of things we would routinely bring in and out of our homes for auditioning/testing!

To me, this library of loudspeaker measurements is John Atkinson's most important legacy since it was him who measured the majority of these products. The published body of work will probably be studied for years to come. (Unlike purely subjective reviews and opinions, mostly already forgotten.)